LED Luminaire (For Road And Street Lights)

philips-15-w-led-street-light-500x500
LED Luminaire (FQ-LEDL0026)
  • LED Rating (in Watts)/System Wattage/RatedPower : 90W
  • Ingress Protection (IP Rating) as per IS:10322 (Part 1):1982 latest : IP66
  • Operating temperature range : -10 deg C to +55 deg C
  • Operating Humidity Range : 10 % to 95% RH
  • Number of electronic control gear (power supplies) : 1 No.
  • Length of ISI marked three core wire (shall be provided along with supply of material) : 50 cm
  • Warranty for free replacement (in years) : 5
Specification
STANDARDS
LED Luminaire conformity to IS:10322/Part 5/Section 3/2012 latest and IS: 16107 (Part 2/Sec 1):2012 latest Yes
Photo biological safety of LEDs used shall be as per IS:16108/2012 (exempt group) Yes
LED Rating 90W
Luminaire System Efficacy (Lumen/watt) >/= 100 Lm/Watt
Ingress Protection (IP Rating) IP66
Warranty for free replacement (in years) 5
ELECTRICAL EFFICIENCY
Input operating Voltage range and frequency 90 to 300 Volts AC at 50 Hz+/-2
Rated voltage 230 V AC 50 Hz
AC Power Factor at full load ≥ 0.95
Driver Efficiency Yes
Total Harmonics Distortion ≤ 10
OPTICAL
LED chip Efficacy ≥130 Lm/Watt
Colour temperature 6000+/-500K
Colour Rendering Index(CRI) ≥70
LED Beam Angle ≥120
Optic lense materal (UV stabilised) Poly carbonate lense
THERMAL MANAGEMENT
Operating temperature range -10 deg C to +55 deg C
Operating Humidity Range 10 % to 95% RH
PROTECTIONT
Short circuit Protection
Over load protecton Yes
Over Voltage protection Yes
Insulation resistance between earth and current carrying part >100 M Ohm
Protection against surges and transients ( Internal) >/=5KV
Protection against surges and transients of >/=10KV (External) Yes
CONSTRUCTIONAL
The Luminaires casing/housing (single piece housing) shall be pressure die casted aluminium alloy with higher thermal conductivity Yes
corrosion resistant powder coated Yes
Protection of the entirehousing (both LED section and driver section) as per IS:10322 (Part 1):1982 latest IP66
Toughned transparent glass cover thickness >/=4 mm
Number of electronic control gear (power supplies) 1 No.
Light Source SMD LED Chip as per LM 80/IS16106
Length of ISI marked three core wire (shall be provided along with supply of material) 50 cm